ATI Technologies Component Video Adapter Guía de usuario Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 72
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
Display Configurations 9
Turning on the System
If you have properly installed your graphics card, operating system
messages will appear once the boot procedure is finished.
Your monitor will be running in a basic video mode. Higher refresh rates
are not available at this stage of the installation. Once you have installed the
FireGL™ drivers and software, you can use the Display Properties control
panel to adjust the video settings and configure multiple monitors.
CRT display +
DFP display +
Quad-buffered
stereographics
device
VGA connector
with VGA-to-DVI-I
adapter +
DVI-I connector +
Quad-buffered
stereographics
Check driver release notes for
limitations on the use of
stereographics.
CRT display +
CRT display +
Quad-buffered
stereographics
device
VGA connector
with VGA-to-DVI-I
adapter +
VGA connector
with VGA-to-DVI-I
adapter +
Quad-buffered
stereographics
Check driver release notes for
limitations on the use of
stereographics.
L
WARNING - Turn on your monitor before you turn on your
computer. Failure to do so could damage your monitor.
Display
Configuration
Connector(s)
Used
Comments
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 71 72

Comentarios a estos manuales

Sin comentarios